Nothing is rejected when it comes to the tiles. You and I know that there are some free material after each job.

We are trying with all that remain, but we do not have enough space to store it. When it is time to do another job comes up, you think that all this material could serve that time and was really a pity to throw it away.

Therefore I would like some ideas on how to use pieces of tile like.

If you have spare tiles, and even parts of an earlier work, they keep in a dry place until you find the right place to find it out. Later, for the paving of a dwelling to be used.

You will need:

* Wool Gear
* Leveler
* Rubber Hammer
* Fund scraper
* Brush
* Autoanivellant
* Substrate suspension initially
* Tile
* Cement
* Float

First, you should check that all the chips are on the same level.

Make sure the floor is perfectly flat work surface. If not, you should do. It is therefore necessary autoanivellant.

Before that, you should have a moratorium on home soil, to reduce the absorption of the plant. Dilute with water and apply it with a big brush. After 2 or 3 hours, which is dry and the ground is ready.

You should start applying the coating autoanivellant in a corner. Such material will be spread throughout the country. Remove with a bottom scraper, remove any air bubbles out of her. After 12 hours it becomes dry and perfectly flat. Always check the instructions of the products do not make mistakes.

If you think that is absolutely dry, you can begin to fix the tiles.

Glue the parts one by one with a wool-equipment. You need this tool to spread the glue on the floor, not more than half feet every time the tiles. Continue like this until all the ground is covered.

The disadvantage of this method is that it will take much longer to implement parts of the application to tiles.

In determining the remains, press carefully with a rubber hammer, and the control plane with a leveler.

This method is simple, even for those who have no construction experience.

Let the glue dry for 24 hours before using it. Later, when it is too dry, cleaned with a damp sponge and a soft cloth.

You can start from any corner of the tiled floor as they do not have to cut tiles around the edges, where the intersections with the walls.

There is also a cheap way to make this work. You can put the pieces directly on the concrete surface and should not apply autoanivellant.

Should always use the leveler work and pay more attention to the irregular pieces of

Be Sociable, Share!

•